What is the best drill and soldering iron for jewelry making?
Pundits Paradigm asked:
I want to drill small holes in metal, plastic, ceramic, etc so that I can add a link to make charms. I need to solder as well. I need info on the supplies/accessories needed (what I need for soldering and drill bits needed) Thank you so much!
This entry was posted
on Sunday, April 18th, 2010 at 12:00 am and is filed under Hobbies & Crafts.
You can follow any responses to this entry through the RSS 2.0 feed.
You can leave a response, or trackback from your own site.
I want to drill small holes in metal, plastic, ceramic, etc so that I can add a link to make charms. I need to solder as well. I need info on the supplies/accessories needed (what I need for soldering and drill bits needed) Thank you so much!
April 21st, 2010 at 11:41 am
Try this one:http://www.nationaljewelerssupplies.com/ They might seem expensive but you only have to buy quality tools once. Steven D
April 22nd, 2010 at 1:21 pm
For your serious jewelry making needs, you will want a torch for soldering, not an iron. You may want to take a class if you’re unfamiliar with using a torch. I would recommend the Smith acetylene/air torch
( ) as a good soldering torch–it’s simple, you only need one fuel tank (and no oxygen), and it’s relatively inexpensive. You can buy a tank at your local welding supply shop.
For drilling, I would recommend a flexshaft. It’s kind of like a dremel, but about a billion times better. If you’re on a serious budget, you can use a dremel, but a flexshaft is much nicer. ( )The link is to a cheapie–the ones made by Foredom are the best, but a cheap one will probably suit your needs. I would get a set of wire gauge drill bits ( ). The set the link is for contains sizes that will correspond to the most common wire gauges. If I remember right, the #68 is for 20g, so if you need to drill smaller, you’ll need a couple more bits. spunk113